INSTALLATION INSTRUCTIONS DODGE DURANGO pdf

STEP 1. Begin by removing the dash cluster trim bezel. Do this by grasping the top of the trim bezel and pull carefully, releasing top clips. A total of eight (8) clips will be released. [Locations of clips are: three (3) on top, four (4) on bottom, and one (1) on the right side of the bezel.] Disconnect all wiring to the bezel. Set bezel aside. STEP 2. Locate a flat spot just below the lower right corner of the radio and to the left of the lower right bezel clip hole. Place Pro.Fit VSMTM over this flat spot. Using the two (2) holes in the Pro.Fit VSMTM as a guide, mark two spots for pilot holes with a marking pen and set mount aside. Using your drill and 5/64” drill bit, drill two (2) pilot holes. STEP 3. Place and align the Pro.Fit VSMTM over the two pilot holes. Insert the two (2) screws provided and tighten with your #2 Phillips screwdriver. STEP 4. Replace the dash cluster trim bezel securing all clips and wiring. Install hang-up cup onto Pro.Fit VSMTM. This completes the installation of your Pro.Fit VSMTM.

http://a248.e.akamai.net/pix.crutchfield.com/manuals/042/042dg7198.pdf

Read more...

Installation Instructions 2000-2002 Dodge Durango pdf

TO START: 1. Remove and inventory JBA exhaust. 2. Disconnect negative battery cable and allow vehicle exhaust to cool. 3. With the vehicle raised and properly supported, use the reciprocating saw to cut the weld at the rear of the muffler. Remove the factory tailpipe. 4. With factory tail pipe removed, the muffler assembly should slid off. 5. With the factory exhaust completely removed, place a muffler clamp (F) over the factory remaining catalytic converter pipe. 6. Install new intermediate pipe (A). 7. Install hangers attached to intermediate pipe (A) into factory rubber isolators. Install muffler (B). 10. Install exhaust clamp (E) at front of muffler. 11. Install hanger clamp (D) at the rear of the muffler. 12. Install tailpipe (C).

http://jbaheaders.com/assets/instruction_sheets/40-1511.pdf

Read more...