2008-2009 Mitsubishi Lancer Evolution

INSTALLATION 1 Using a 12mm socket with ratchet, loosen the nut on the main power distribution block and remove the main power cable. Live power. Dynojet recommends covering the end of the cable with electrical tape to avoid shorting the main power lead. 2 Remove the red and black engine cover. Figure A Figure B Figure C crank located underneath engine ground bolt fuse box main power boost MAF TPS fuel injectors MAP loosen nut ICMD-1112.01 2008-2009 Mitsubishi Lancer Evolution… – CMD-1112 – 3 3 Locate the boost control solenoid connector. The boost control solenoid connector is located near the main power distribution and the air box as shown in Figure A and D. 4 Unplug the boost connector from the boost solenoid. 5 Attach the male boost connector from the CMD harness to the female OEM connector. 6 Attach the female boost connector from the CMD harness to the OEM solenoid. 7 Locate the MAF sensor connector. The MAF sensor connector is located near the main power distribution and the air box as shown in Figure A and F. 8 Unplug the MAF connector from the MAF sensor. Figure D Figure E Figure F boost control solenoid connector ICMD-1112.01 2008-2009 Mitsubishi Lancer Evolution – CMD-1112 – 4 9 Attach the male MAF connector from the CMD harness to the female OEM connector. Note: Verify the connectors are secured properly by giving the wires a light tug. 10Attach the female MAF connector from the CMD harness to the OEM sensor located on the factory air box. 11Locate the 10mm bolt on top of the PCM cradle. 12Secure the CMD ground wire to this bolt. Figure G Figure H Figure I bolt for ground ICMD-1112.01 2008-2009 Mitsubishi Lancer Evolution – CMD-1112 – 5 13Route the CMD harness under the boost and bypass hoses to the top of the engine near the coils. Zip ties are provided for a clean installation. Make sure to leave enough room for engine movement. 14Locate and disconnect the injector connectors…

Power Boost, Fuel Injectors, Mitsubishi Lancer