Installation Instructions 2000-2002 Dodge Durango pdf

TO START: 1. Remove and inventory JBA exhaust. 2. Disconnect negative battery cable and allow vehicle exhaust to cool. 3. With the vehicle raised and properly supported, use the reciprocating saw to cut the weld at the rear of the muffler. Remove the factory tailpipe. 4. With factory tail pipe removed, the muffler assembly should slid off. 5. With the factory exhaust completely removed, place a muffler clamp (F) over the factory remaining catalytic converter pipe. 6. Install new intermediate pipe (A). 7. Install hangers attached to intermediate pipe (A) into factory rubber isolators. Install muffler (B). 10. Install exhaust clamp (E) at front of muffler. 11. Install hanger clamp (D) at the rear of the muffler. 12. Install tailpipe (C).

http://jbaheaders.com/assets/instruction_sheets/40-1511.pdf